Conclusions and recommendations
If there are not any recommendations to be manufactured because essaypro review of the project, just call this section Conclusions.
The Conclusions section sums up the important thing points of one’s discussion, the essential top features of your design, or perhaps the significant outcomes of one’s investigation. As its function is to round from the story of any project, it must:
- be written to relate straight to the aims associated with the project as stated within the Introduction
- indicate the extent to that the aims have been achieved
- summarise the findings that are key outcomes or information in your report
- acknowledge limitations while making recommendations for future work (where applicable)
- Highlight the usefulness or significance of your work.
The conclusions should relate genuinely to the aims of the work:
The goal of this project is to design a mobile phone tower for a suburban location..
The cell phone tower presented here could be erected safely in a street that is suburban.
It requires a total part of no more than 2m 2 l, and has now the following safety features.
This investigation will review the quantity of passengers making use of the Monash University Clayton-Caulfield inter-campus bus to be able to recommend adjustments to your ongoing service if needed.
Analysis of the survey data obtained in this project demonstrates that use of the Clayton-Caulfield inter-campus bus has grown by 24% in the past 5 years. It is strongly suggested that frequency be increased during peak usage.
The Conclusions section below is from a known level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Click the buttons that are coloured look at comments.
Each one of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the discussion that is preceding. In this full case, it indicates that the aims of this project have already been met. presented in this report fulfil the criteria specified in the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this full case one of the keys popular features of the designs – are then recapped. incorporate round piers on piled foundations, that are used considering that the soil conditions are unknown and possibly unstable. Design 1, a straightforward i-girder that is composite, gets the advantageous asset of being made of steel and therefore has longer spans and fewer piers.
Design 2, a beam that is super-T >Design 2 Lecturer’s comment:
The importance of the results – in this situation the ultimate recommendation – is obviously stated. is therefore recommended. It includes Lecturer’s comment:
To finish off, the achievement of this project is reinforced. a reasonable overpass with superior durability, and fully meets the requirements of this design brief.
Always address limitations and suggest how they may be overcome in future work. The below that is excerpt through the Conclusions of a study on a project investigating the effect of pulsation on heat transfer in horizontal pipe flow.
Experimental results Lecturer’s comment:
Key conclusions drawn through the project. showed that pulsed flow without flow reversal had no effect that is significant with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. It is likely due Lecturer’s comment:
Provide a explanation that is possible notable results, especially unexpected ones. into the large disturbances in the hydrodynamic boundary layer once the flow changes direction. Further research Lecturer’s comment:
Recommend further research to handle any work that is extra think will be useful. is recommended to determine the most achievable enhancement.
It should be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations and/or solutions. the experimental results try not to buy into the equations that are theoretical. This can be because of the deposits which developed inside the pipe, or to inconsistent thermocouple temperature. Therefore, regular inspection associated with test rig is advised.
For a rather report that is long it is acceptable to present the conclusions and recommendations in point form:
The prototype robot courier presented here has been confirmed to allow you to delivering documents autonomously in an office environment. It offers demonstrated listed here aspects of mobile robotics:
- Localisation: The Kalman localisation that is filter-based achieved sub-centimeter accuracy under normal operating conditions.
- Environment modelling: The occupancy map was updated dynamically to incorporate obstacles not included in the map that is original.
- Path planning: A distance path that is transform-based using obstacle transforms produced a globally optimal local entrapment-free way to the target.